30% Off MSRP

BOSCH DS150i Series Request-to-exit Detectors

$144.20 ~~$206.00~~

Overview

The DS150i Series consists of the DS150i Detector (light gray) and the DS151i Detector (black). They are specifically designed for Request-to-exit (REX) applications.

The DS150i and DS151i detect motion in their coverage area and signal an access control system or door control device.

UL, CE and RCM certifited

Product Overview

The DS150i is a passive-infrared detector designed for request to exit (REX) applications. It is UL Listed as an access control device under the UL 294 standard and is listed for Class I for UL Canada (ULC-S319). For C-UL listed installation applications, the REX shall be connected to ULCS319 listed compatible devices (i.e. control units, power supply and locks). Intended for indoor use only.

Standard Features

Single or Double Door use
Wall or ceiling mountable
Internal vertical pointability
Wrap-around coverage pattern
Selectable relay trigger mode

Technical Specifications

Alarm output: Two form C relay contacts
Indicators: One activation LED
Relay Latch Time: Adjustable to 60 sec.
Enclosure Dimensions: 6.25 inch L x 1.5 inch W x 1.5 inch D
Enclosure Material: High impact ABS plastic
Power Loss Default Mode: Programmable fail-safe or fail-secure modes
Timer Mode: Programmable reset (accumulative) or non-reset (counting) mode.
Mounting Location: Surface mount on wall or ceiling
Voltage: 12VAC or VDC, 24 VAC or VDC
Current Draw: 26 mA at 12 VDC
Operating Temperature: -29°C to +49°C (-20°F to +120°F)

Models

DS150i - light gray
DS151i - black

Also Known As

DET200DS150I, DS-DS150I, BOS-DS150I

Finish

(selectable)

Manufacturer

Bosch

Model Number

DS150i, DS151i

Power Requirements

24V/12V AC/DC

UPC Code

8717332791712

Usage

Interior Use Only

Datasheet PDF

Installation PDF

4 Questions asked on BOSCH DS150i Series Request-to-exit Detectors • Ask a Question

Q Adam Levenson • 08/25/2023, 6:07:22 AM Will it work with a standard mag lock system? I want to remove the "push to exit" buttons and replace with these detectors... Could they be wired in the same as the button or keypad?

A 08/25/2023, 11:27:27 AM Yes, these Bosch Motion sensors can be used to cut power directly to a magnetic lock for egress purposes. Typically you would run power "in-series" through one of the SPDT relay contacts on this sensor direct to the lock, when the sensor activates the relay would break the flow of power allowing the magnet to release. To go over this product in further detail please give us a call direct at 1-866-500-5625

Q Clay Johnson • 03/15/2024, 8:11:59 AM Is the BOSCH DS150I SERIES REQUEST-TO-EXIT DETECTORS a sensor that is wired into a magnetic lock that will disengage when the sensor is tripped.

A 03/15/2024, 4:55:13 PM Yes, that is correct. The DS150 series motion sensor can be wired to cut power directly to the magnetic lock allowing for a safe egress. For any additional questions regarding this sensor or for help configuring a complete system please give us a call direct at 1-866-500-5625